Liquid-controls Mechanical Eliminators Manual de usuario descargar pdf (Pagina 19)







1. Remove the 4 screws and washers at the base of the air

eliminator. Pull the air eliminator off the strainer.

2. Remove the bafe plate and the bafe cup (aluminum

air eliminators only) from the housing. If the air eliminator

has a lock nut and a bushing on the bottom of the guide

post, remove them.

3. Remove the cover screws from the air eliminator cover

with a 1/2 inch wrench or socket, and pull the cover, vent

plate and seal ring from the housing.

4. To remove a reed strip that is still intact, hold down the

reed strip and unscrew the reed screw (shown on the

top right). Gently allow the reed strip to straighten. Reed

strips violently snap back if they are not held down while

removing the reed screw. Failure to hold down the reed

strip could result in injury and is the cause of many lost

screws.

5. Pull the oat, along with the attached reed strips, out from

the bottom of the air eliminator (shown on the right). If

the oat is heavy and full of product, replace it with a new

oat assembly.

6. If one of the reed strips is broken, remove it and replace

with a new reed strip.

7. Begin reassembly. Push the oat, along with the attached

reed strips, up into the air eliminator cavity. Pull the reed

strips out of the side slots (shown on the right). Hold the

reed strips down and screw them down with the reed

screws. If the air eliminator had a lock nut and a bushing

on the bottom of the guide post, replace them.

8. Replace the valve plate, cover gasket, and cover. Tighten

the cover screws to a torque of 17.5 - 20.5 ft-lbs.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Sin comentarios

Liquid-controls Mechanical Eliminators Manual de usuario Pagina 19