Liquid-controls Mechanical Eliminators Manual de usuario descargar pdf (Pagina 29)







Return Material Authorization request forms are included in the red literature

packet of every Liquid Controls product shipment. They are also available at

www.lcmeter.com under the “Publications” menu selection.

Do not return a Liquid Controls component until all traces of hazardous substances have been

removed. For example, substances that have diffused through plastic or remain in crevices.







!



All returned parts must be cleaned by customers prior to return shipment.The person who actually cleaned the parts

is required to complete the Return Material Authorization form. If the component has been contaminated, customers

must include an M.S.D.S. sheet with the return shipment. If a part is returned without the proper paperwork, the

service department will contact the sender and attempt to procure the correct documents. If the proper paperwork is

not received within ten days of receipt, the parts will be sent back to the customer for correction.

Many Liquid Controls employees handle returned components, and they are exposed to substances left behind on

the components. It is our intention to make handling these parts as safe as possible. We regret any hardship these

stipulations may cause, but because of the many different applications we service, it is a necessary precaution taken

to protect our employees.





1. Remove all residue from the Liquid Controls component(s) to be returned. Make sure the grooves and corners around or inside

seals and crevices are cleaned. This is particularly important if the component was in contact with hazardous materials. See

Warning and Handling Procedure printed below.

2. Complete the Return Material Authorization request form.

3. If necessary, include special handling instructions, such as MSDS forms or certications.

4. Attach the completed Return Material Authorization request form, the MSDS form, and the packing slip to the outside of the

box.

1 2 ... 24 25 26 27 28 29 30 31 32

Sin comentarios

Liquid-controls Mechanical Eliminators Manual de usuario Pagina 29